Porcelain tile
Hardwood
Engineered hardwood
Luxury vinyl plank
Laminate
Carpet
Shaw
Mohawk
COREtec
PergoFree in-home measure and written estimate: Shaw, Mohawk, COREtec and Pergo lines compared on your own rooms, with carpet, tile, vinyl plank, laminate and hardwood laid out side by side
Get your free estimateTrusted Tile Flooring Installation for Enterprise Homeowners
Tile is the one floor that fails from the ground up, not the top down. A hollow tap under the grout or a hairline crack that keeps returning almost always traces back to a subfloor that wasn’t flat or a thin-set that never bonded, and in Enterprise’s heat and dry desert air, a slab that shifts and a tile laid over it without a proper prep layer will telegraph every one of those problems within a couple of seasons. Our technicians have up to 12 years of experience setting porcelain, ceramic, and large format tile on floors that have to hold up to desert temperature swings and hard indoor use, and we work from nine manufacturer brands so the tile you pick is actually matched to the room. Call (833) 620-6314 to schedule your free estimate. We install floors, we don’t sell them out of a showroom.
What Our Tile Flooring Installation Service Includes
Tile flooring installation is the supply and installation of a hard-surface tile floor over a prepared subfloor, including tile removal when there’s an old floor to take up, plus regrouting when the tile itself is fine but the grout lines are shot. Here’s how we break down each piece.
Porcelain Tile Installation
Porcelain tile is dense, water-resistant, and the right pick for kitchens, hallways, and any floor that sees foot traffic and occasional spills. It’s a good fit for Enterprise homes because the material handles indoor temperature swings without the movement a softer tile shows. We set porcelain over a prepped, level subfloor with the correct thin-set and grout line width for the tile size, and we walk you through whether glue-down or a backer system makes more sense for your slab.

Bathroom Floor Tile Installation
Bathroom floors are the job most likely to fail if the subfloor prep gets skipped, because moisture from below and around the fixtures is constant. We give bath floors extra attention at the perimeter, around the toilet flange, and at the transition to the hallway so water doesn’t find a seam. Porcelain and ceramic both work well here, and we’ll talk through grout selection and the seal where the floor meets the wall before we set a single piece.

Large Format Tile Installation
Large format tile covers more floor with fewer grout lines, which reads clean and modern in open living and dining areas. The catch is that large tile demands a flatter, more rigid subfloor than a small-format tile because the tile can’t flex to follow a dip or a hump. We check flatness at the estimate and plan the prep layer, thin-set coverage, and layout before the tile goes down, so the finished floor sits level across the whole room.

Ceramic Tile Floor Installation
Ceramic tile is the budget-conscious hard surface for kitchens, laundry rooms, and entryways where you want tile durability without porcelain’s price point. It’s slightly softer and better suited to lower-traffic rooms, and it still needs proper subfloor prep to hold. We help you compare ceramic against a porcelain option side by side so the material fits the room, not just the price sheet.
Tile Removal
Tile removal is taking up an existing tile floor down to the subfloor so the new floor has a clean surface to bond to. Skipping this step and tiling over old tile usually leads to a thicker, uneven floor and a bond that lets go early. We handle the demo, haul-away, and subfloor inspection as part of a full install, and we check what’s underneath for cracks or moisture before the new tile goes down.
Tile Regrouting
Regrouting replaces worn, cracked, or stained grout when the tile itself is still sound, which saves you a full replacement. If the grout lines are crumbling or the floor looks dingy no matter how much you scrub, regrouting restores the look and locks the joints back up. We confirm the tile is still well bonded first, because regrouting a floor with loose tile just delays the real fix.
Styles & brands we work with
- Hardwood
- Engineered hardwood
- Luxury vinyl plank
- Laminate
- Porcelain tile
- Carpet
- Shaw
- Mohawk
- COREtec
- Pergo
Brands We Service for Tile Flooring Installation
We install and service tile from Daltile, Mannington, and Armstrong, among the nine brands we carry and install, and each one has a different character we’ve learned to work with. Daltile is a porcelain and ceramic standby, and we know its tile sizes well enough to plan layout and grout line width around the actual pieces. Mannington and Armstrong give us options across the hard-surface range, and we match the product to the room and the subfloor rather than pushing whatever’s on hand.
For rooms where you’re weighing tile against a warmer or more water-tolerant floor, we also install Karndean and Shaw so you can see the trade-offs in one conversation. Nine trusted brands. One installation crew. Whether your project points toward Daltile, Mannington, Armstrong, or any other name we carry, we can help.
Signs You Need Tile Flooring Installation Right Now
- Hollow sound when you tap the floor. A dull, hollow tap means the tile has come loose from the thin-set below. Left alone, the loose tile spreads and cracks, and the fix grows with it.
- Cracks that keep coming back. A single hairline crack can be a fluke; cracks that return after a repair usually point to subfloor movement or a prep problem. That’s a sign to check the base, not just patch the tile.
- Grout lines that are crumbling or stained. Crumbling grout lets moisture into the joints and under the tile, and stained grout that won’t come clean means the surface is worn through. Regrouting or a full replacement is the call, depending on the tile.
- Loose or lifting tile at the edges. Tile that’s lifting at a doorway or along a wall is often a sign the floor wasn’t prepped flat. It’s worth a look before a trim piece hides a bigger problem.
- A bathroom floor that stays damp or smells musty. That usually means water is getting under the tile through a failing grout line or a bad seal at the flange. Fixing the tile and the seal together stops it from coming back.
Our Tile Flooring Installation Process – Step by Step
- 1
Free in-home measure and estimate. We come out, measure the room, check the existing floor, and look at the subfloor for flatness and movement. You get a written price before anything is ordered, and the estimate is free.
- 2
Product and layout plan. We talk through porcelain versus ceramic, tile size, grout line width, and layout so the pattern reads right in the room. You pick from the brands we carry, and we confirm what the product instructions and the written estimate set for the install.
- 3
Removal and subfloor prep. If there’s an old floor to take up, we demo and haul it away, then inspect what’s underneath. Prep is where the install is won or lost, so we get the subfloor flat and sound before the first tile goes down.
- 4
Installation day. The crew sets the tile with the correct thin-set and spacing, working from a layout plan so the cuts land where they should. The install day is booked at the estimate, and the schedule is set at that visit.
- 5
Grout, seal, and walkthrough. We grout, seal where it’s needed, clean up, and walk the finished floor with you. If anything needs a second look, you know exactly who to call.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Tile Flooring Installation Cost in Enterprise?
A typical tile flooring installation in Enterprise runs $3000 – $9000 for a 500 to 800 square foot project, materials and labor included, and the written estimate sets the final price. That range covers a standard porcelain or ceramic floor installed over a prepared subfloor, and the low end fits a smaller room with a sound subfloor while the high end fits a larger space or one that needs removal and prep work first.
Several things push the price up or down: the tile material and size, how much subfloor prep the room needs, whether there’s an old floor to remove, and how much detail work the layout requires around doorways and fixtures. Large format tile costs more to set because it needs a flatter base and more careful handling. Tile starts around $7 per square foot, but the exact per-square-foot figure depends on the product, the room, and the subfloor, so treat that as a starting point, not a quote.
To avoid overpaying, get the subfloor condition checked at the estimate and ask for a written scope that lists removal, prep, tile, grout, and cleanup separately. A free estimate from us includes the measure, a look at the subfloor, and a written price, with no obligation. Call (833) 620-6314 for an exact quote on your room, and estimates are free.
Tile Flooring Installation Near Enterprise – Our Service Area
We install tile flooring across Enterprise and the surrounding Las Vegas Valley, including Spring Valley, Summerlin, Paradise, Winchester, Whitney, Sunrise Manor, North Las Vegas, Henderson, Boulder City, and out toward Sandy Valley. Response times vary by location and by how booked the schedule is, and the install day is set at the estimate visit. If you’re comparing options, we also handle tile flooring installation and tile flooring installation in those neighborhoods with the same crew and the same written-price approach.
Serving Enterprise, NV – Our Local Coverage Area
We serve Enterprise and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Tile Flooring Installation in Enterprise
Tile flooring installation is the supply and installation of a hard-surface tile floor over a prepared subfloor, including removal of an old floor when needed. It covers porcelain, ceramic, and large format tile, plus regrouting when the tile is sound but the grout isn’t. We install the floor you choose from the brands we carry, and the written estimate spells out exactly what’s included. Call (833) 620-6314 to talk through your room.
The schedule is set at the estimate visit, so we can’t give you a fixed number before we see the room. How long the job takes depends on the square footage, the tile size, how much subfloor prep is needed, and whether there’s an old floor to remove. We confirm the install day and the plan in the written estimate so you know what to expect. Call (833) 620-6314 to book your free measure.
A typical tile flooring installation in Enterprise runs $3000 – $9000 for a 500 to 800 square foot project, materials and labor included, and the written estimate sets the final price. Tile starts around $7 per square foot, but the exact figure depends on the product, the room, and the subfloor. Call (833) 620-6314 for an exact quote, and estimates are free.
Yes. We install and service tile from Daltile, Mannington, and Armstrong, along with other brands we carry, and we match the product to the room and the subfloor. We’re an installer, not a showroom, so we help you choose from the brands we work with and set the floor yourself. Call (833) 620-6314 to talk through which tile fits your project.
Same-day service is available for some jobs, and whether your install can happen same day depends on the room and the schedule. We answer 24/7, and fast dispatch runs from 7am to 7pm, Sunday through Friday, and we’re closed Saturday. A call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm. Call (833) 620-6314 to schedule.
We back our work through the written estimate, which spells out the scope and what’s covered, and the product warranty comes from the manufacturer and depends on the tile you choose. We don’t quote warranty terms before the product is picked, because they vary by line. Ask at the estimate and we’ll go over what applies to your floor. Call (833) 620-6314 to get started.
Clear the room of furniture and breakables, and make sure we can get to the floor and the water shutoff if a bathroom is involved. Take up area rugs and anything on the walls that could be bumped, and plan for the room to be out of use on install day. We confirm the details when we book your install. Call (833) 620-6314 to set up your free estimate.
If your project spans more than tile, we also handle Enterprise Flooring Installation across carpet, tile, and hardwood, and you can read more about tile flooring installation on our main page. We refinished hardwood too, and you can see our hardwood floor refinishing page for the refinishing side of the work.
Schedule Your Tile Flooring Installation Service in Enterprise Today
Ready to get a real number for your tile floor? Call (833) 620-6314 to schedule your free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. We’ll come out, measure the room, check the subfloor, and give you a written price with no obligation, so you can decide with the facts in front of you.
Written by the team at Enterprise Flooring Installation.